Owner`s manual

Gas Cylinder Storage, Placement and Filling:
 Do not store a spare LP-gas cylinder under or near appliance.
 Never fill the cylinder beyond 80 percent full. Over-filled cylinders can release gas.
 The gas cylinder safety relief valve may overheat, allowing gas to release causing an intense fire with
risk of death or serious injury.
 If you smell, hear, or see gas escaping i
mmediately move away from the gas cylinder and call the Fire
Department for assistance. A fire causing death or serious injury may occur.
 Place a dust cap on cylinder valve outlet whenever the cylinder is
not in use. The included dust cap should be the only dust cap
applied to the cylinder valve outlet.
 Other caps or plugs may cause leaks.
Gas Cylinder Storage and Appliance Check:
 Cylinders must be stored outdoors, out of reach of children, and must not be stored in a building,
garage, or any other enclosed area.
 Before each use check all nuts and bolts to be sure that they are tight and secure.
 Before each use inspect gas hose for any signs of damage.
 Before each use pe
rform a soapy water test.
LP Tank Removal, Transport and Storage:
 Turn off all control knobs and LP tank valve. Turn coupling nut
counterclockwise by hand only – do not use tools to disconnect. Install
safety cap onto LP tank valve. Failure to use safety cap as directed may
result in serious personal injury and/or property damage.
 A disconnected LP tank in storage must have a safety cap installed (as
shown). Do not store an LP tank in enclosed spaces such as a carport,
garage, porch, covered patio or other building. Never leave an LP tank
inside a vehicle which may become overheated by the sun.
 Do not store LP tanks in an area where children play.
The tank used with your appliance must meet the following requirements:
 Purchase LP tanks only with these required measurements: 12” (30.5cm) (diameter) x 18” (45.7
cm)(tall) with 20 lb (9 kg) capacity maximum.
 The LP tank must be constructed and marked in accordance with specifications for LP tank of the
U.S. Department of Transportation (DOT). See LP tank for marking.