Owner's Manual

3 The trigger pull adjustment screw is located just in front of the

trigger (Figure 11). To increase the weight of the trigger pull, turn

the adjustment screw in a clockwise direction using a 2mm Allen

wrench. To decrease the weight of the trigger pull, turn the

adjustment screw in a counterclockwise direction. NOTE: If trigger

pull is increased too much, the trigger cannot be pulled. Turn the

screw counterclockwise until trigger can be pulled.

4 Trigger pull can be measured, with the rifle unloaded and the

bolt closed, using a very accurate spring scale or a commercially

available set of trigger pull measuring weights. Most gunsmiths

can also measure trigger pull for you.

5 When finished making the adjustment, replace the trigger guard

back in the stock and reinstall the trigger guard screws snugly.

CLEANING AND MAINTENANCE SUGGESTIONS

NOTICE! Please taKe note of the following information Before

cleaning your firearm.

CLEANING PARTS WITH SPECIAL FINISHES

Be especially careful when cleaning guns with camouflage, Dura-Touch

Armor Coating and other special finishes. Always prevent these

figure 11

Adjust the trigger pull using a 2mm

Allen wrench.

figure 10

Remove the two screws and lift the bottom

metal from the stock.

09-044-BFA_XBolt Rifle OM.indd 23 2/10/09 2:29:24 PM