Owner's Manual

28
To maintain the utmost accuracy of your rifle it is recommended
you clean the bore with a copper solvent. Modern bullet jackets are
made mainly of copper. Residues from copper bullet jackets stick to
the barrel and require more frequent cleaning. Magnum calibers
will require more frequent inspection and cleaning. Swab the bore
of your rifle with a good copper solvent using the manufacturer’s
recommended procedure.
Browning offers a complete line of products to make cleaning your
firearm fast and easy. Be sure to follow all instructions when using
any product to clean your firearm.
3 After all fouling has been removed, the chamber and bore should
be wiped dry. When the bore is dry, pass a slightly oiled patch
through it for preservation. A fine, light gun oil is recommended.
4 Inspect the barrel and chamber to be certain no patches have
inadvertently been left in them. Remove any that remain.
5 Use a small brush or rag to remove dirt or other foreign matter
from inside the receiver and other parts of the action. Lightly
lubricate all moving parts with a high-quality, light gun oil. Use
oil sparingly, a very light film is sufficient. A fine, light gun oil is
ideally suited for this purpose.
DO NOT POUR LARGE QUANTITIES OF OIL INTO THE RECEIVER OR OTHER
PARTS. IT CAN DRAIN DOWN TO THE WOOD AND SOFTEN IT, CAUSING
PERMANENT DAMAGE AND LOOSENING OF THE STOCK.
6 Wipe all exposed metal surfaces with a lightly oiled cloth making
certain that all finger marks are removed. Finger marks provide a
place where moisture can accumulate. The metal of the gun should
receive a light film of oil any time the rifle has been exposed to
weather or handling.