Owner's Manual

3 The trigger pull adjustment screw is located just in front of the

trigger (Figure 11). To increase the weight of the trigger pull, turn

the adjustment screw in a clockwise direction using a 2mm Allen

wrench. To decrease the weight of the trigger pull, turn the

adjustment screw in a counterclockwise direction. NOTE: If trigger

pull is increased too much, the trigger cannot be pulled. Turn the

screw counterclockwise until the trigger can be pulled.

4 Trigger pull can be measured, with the rifle unloaded and the

bolt closed, using a very accurate spring scale or a commercially

available set of trigger pull measuring weights. Most gunsmiths

can also measure trigger pull for you.

5 When finished making the adjustment, replace the trigger guard

back in the stock and reinstall the trigger guard screws snugly.

MUZZLE BRAKES AND SUPPRESSORS

THE ADDITION OF A RECOIL REDUCING MUZZLE BRAKE SIGNIFICANTLY

INCREASES NOISE AND MUZZLE BLAST. YOU, AND EVERYONE IN

CLOSE PROXIMITY TO THE FIREARM, SHOULD ALWAYS WEAR HEARING

PROTECTION TO HELP PREVENT HEARING LOSS OR DAMAGE AND SAFETY

GLASSES TO HELP PREVENT DEBRIS FROM INJURING THE EYES.

FIGURE 11

Adjust the trigger pull using a 2mm

Allen wrench.

FIGURE 10

Remove the two screws and lift the bottom

metal from the stock.