Owner's Manual

8 Tighten the screws evenly, in

the pattern shown in Figure 9.

This will allow the screws to be

tightened with equal pressure.

Tighten the screws snugly, but

do not overtighten.

9 Mount your scope rings and

scope as outlined in the

instructions supplied with your

scope rings and/or scope. Always

make sure you have the proper

eye relief.

TRIGGER ADJUSTMENT

BEFORE ADJUSTING THE TRIGGER, ALWAYS PLACE THE “SAFETY” IN THE

ON SAFE POSITION. KEEP THE MUZZLE POINTED IN A SAFE DIRECTION

AND YOUR FINGERS AWAY FROM THE TRIGGER. FAILURE TO FOLLOW

THESE WARNINGS COULD RESULT IN SERIOUS INJURY OR DEATH.

ALWAYS INSPECT THE CHAMBER, BARREL AND MAGAZINE CAREFULLY

AFTER UNLOADING TO BE SURE ALL LIVE CARTRIDGES ARE CLEARED

FROM THE FIREARM.

The X-Bolt’s trigger is pre-set at the factory. The trigger pull weight

can be adjusted within a range of approximately 3 to 5 pounds, and is

factory pre-set at 4 pounds. Though additional trigger adjustments

should be unnecessary, the trigger pull weight can be tuned to your

specifications by performing the following procedure:

1 Remove the magazine from the rifle by pressing the magazine

release button. Open the bolt and verify the rifle is unloaded.

2 Remove the two screws that retain the bottom metal with a 4mm

Allen wrench (Figure 10, page 24). Lift the bottom metal out of

the stock.

FIGURE 9

Tighten the screws incrementally in the pattern

shown above.