Manual

and is inserted into the top of the magazine
housing through the receiver opening after
the breech bolt ht:ts been removed (Fig-
ure 4). The loading ramp has a horizontal
slot through its axis and should be inserted
with the open end of the slot toward the cham-
ber. With reasonable pressure with the thumb
of either hand the ramp will snap and lock
into place just below the level of the chamber.
Then try the bolt carefully to be sure the
ramp is properly seated and does not obstruct
the movement of the
breech bolt. Either .22
Short, Long, or Long
Rifle cartridges may
be dropped on the
loading ramp and fed
into the chamber by
closing the breech bolt
in conventional single
shot fashion.
3. In the magazine
recess in the bottom
of the stock, insert
Adapter Piece (B)
(Figure 4), which
merely serves as an
enclosure. It is insert-
ed with the lip for-
ward or toward the
muzzle and snapped
into place with slight
thumb pressure.