Owner's Manual

45
REMOVING THE TRIGGER GROUP
1 Place the bolt in the forward position by holding the operating
handle and depressing the bolt release button.
NEVER ALLOW THE ACTION TO SLAM CLOSED BY PRESSING THE BOLT
RELEASE BUTTON WITHOUT THE BARREL INSTALLED. IF THE BOLT IS
RELEASED FORWARD WITH THE BARREL REMOVED, THE OPERATING
HANDLE WILL STRIKE THE RECEIVER AND CAUSE DAMAGE.
2 Use a punch or similar object to push inward on the trigger guard
pins, taking care not to scratch the receiver (Figure 28). Trigger
group pins may be removed from either side of the receiver. Push
the trigger group pins through the receiver. Pull on them from the
opposite side to remove them.
3 Grasp the trigger guard and pull it up and out of the receiver
(Figure 29).
4 Perform any cleaning of the parts and receiver cavity as necessary.
We suggest cleaning the trigger group with a quality aerosol gun
solvent. Allow it to dry and then very lightly oil the moving parts.
DO NOT DISASSEMBLE THE TRIGGER GROUP BEYOND THIS POINT.
FIGURE 29
Lift the trigger group from the receiver.
FIGURE 28
Push the trigger group pins through
the receiver.