Install Instructions

JA-P
STD. MOUNT
(MOST SIZES)
JA-J
REVERSE MOUNT
ILLUSTRATION 1B - - QD ASS’Y, FLANGE OUTBOARD
ILLUSTRATION 2A - - QD COMPONENTS, FLANGE INBOARD
REVERSE MOUNT
JA-J
(MOST SIZES)
STD. MOUNT
JA-P
JA-P
STD. MOUNT
(MOST SIZES)
JA-J
REVERSE MOUNT
ILUSTRATION 2B - - QD COMPONENTS, FLANGE OUTBOUND
Mounting:
3. For light weight products, the bushing may first be loosely installed into the Q-D bored
product, hereafter referred to as “product”, and then the assembly slid onto the shaft
(Illustration 1A and B). For heavier products, it is usually easier to either first slide the
bushing onto the shaft, then slide the product onto the bushing (Illustration 2A), or first
position the product over the shaft, next slide the bushing onto the shaft, and then pull the
product onto the bushing (Illustration 2B). The “light weight products” method is common,
however if the bushing barrel has collapsed, it must be wedged open (described below),
and the “heavy product” procedure may be easier.
Heavier product may require a hoist or other means of holding the product in position until
the bushing is inserted into the product. When mounting on a vertical shaft, make sure the
bushing and the product do not drop during installation.