User Guide

assembly against the
recoil spring and slide
the assembly into the
appropriate recess in
the slide (Figure 15).
6. Align the lock-
washers over the
screw holes in the
scope base.
ALWAYS USE THE
SCOPE BASE SCREW
LOCKWASHERS
SUPPLIED WITH YOUR RIFLE. FAILURE TO USE A BROWNING SCOPE
BASE SCREW LOCKWASHER MAY MAKE IT VERY DIFFICULT TO REMOVE
THE BASE SCREWS.
7. Position the sight base in place and install the screws. The rear
screw is the longer of the two.
8. Check all screws to make sure they are tight.
CLEANING SUGGESTIONS
WEAR EYE PROTECTION WHEN DISASSEMBLING AND CLEANING
YOUR RIFLE.
1. Disassemble the rifle as previously described in the section
“Disassembly” on page.
2. The Slide assembly my be cleaned with any good cleaning solvent or
light oil and then dried with a clean cloth, or preferably blown clean
with air pressure, if available. Be sure to wear eye protection whenever
cleaning your rifle.
3. Clean the barrel using a cleaning rod with a tip and a patch made
for .22 caliber rifles. Depending on the amount of use, the barrel may
17
FIGURE 15
Correct positioning of buffer
99611/BUCKRIFLE OM 8/12/03 8:27 AM Page 17