User Guide

8. To remove the bar-

rel, pull the barrel

forward and pivot it

down and then lift

the barrel off of the

frame (Figure 13).

9. This is sufficient

disassembly for all

practical cleaning and

lubrication required

for a fully disassem-

bled Standard Buck Mark (Figure 14). Further disassembly should be

performed only by a competent gunsmith or the Browning service

facility. Do not remove the grips from the pistol, as they serve to retain

and position internal parts.

REASSEMBLY

1. Replace the barrel. Tip the barrel block into the recess in the frame.

(See Figure 13 again) Pivot the barrel up until the barrel comes into

alignment with the frame.

2. Tighten the barrel mounting screw.

3. Replace the forearm on the barrel.

4. Replace the slide

on the frame.

5. Make sure the

buffer is in place on

the recoil post, with

the guide rod

attached at the top.

Push the firing pin

FIGURE 13

Removing the barrel

FIGURE 14

Do not disassemble beyond this point

99611/BUCKRIFLE OM 8/12/03 8:27 AM Page 16