User Guide

UNLOADING

To remove the

cartridge remaining

in the chamber, be

certain the muzzle is

pointed in a safe

direction, raise the

thumb “safety” lever

to its “on safe”

position, press the

magazine release

button and withdraw the magazine from the rifle. Then move the

“safety” to the “off safe” position and slowly pull rearward on the slide

to extract and eject the cartridge from the chamber.

INSPECT THE

ACTION AND CHAMBER TO BE SURE NO LIVE CARTRIDGE REMAINS IN THE

RIFLE

. With the magazine removed, the stop open latch must be raised

manually to hold the slide open.

SIGHT ADJUSTMENT

Target model — The heavy-barreled target model comes with an

integral scope rail and no sights. It is intended to be used with a scope

or electronic sights only. These optical sights are sold separately. To

adjust them, follow their manufacturers’ instructions.

Sporter model — The tapered-barreled sporter model comes with

an integral scope mount and high-visibility fiber optic sights. No

adjustment of the front sight is necessary. Adjust the rear sight as

follows: Elevation — Forward adjustment screw (Figure 9). To raise

the point of impact, turn clockwise. To lower the point of impact, turn

counter-clockwise. Windage — Adjustments are made by loosening

the rear set screw and sliding the sight assembly to the left or right by

hand. Be sure to tighten the set screw after adjusting. Move the

assembly in the direction you would like point of impact to go.

CAUTION: Use only a damp cloth to clean the fiber optic light pipes. Use

of solvents or other chemicals could damage the light pipes.

FIGURE 9

Adjusting the sight

99611/BUCKRIFLE OM 8/12/03 8:27 AM Page 13