Owner's Manual

sight. To move the point of impact

to the LEFT, loosen the screw on

the left side of the sight and tighten

the screw on the right side. This is

a process of trial and error. Make

small adjustments, then check the

point of impact.

VERTICAL ADJUSTMENT

Vertical adjustment is controlled by

two screws located on top of the

sight. To RAISE the point of

impact, loosen the front screw and

then tighten the rear screw. To

LOWER the point of impact, loosen the rear screw and then tighten

the front screw. Vertical adjustment is also a process of trial and error.

The Deer model is supplied with a receiver scope mount base. The

Turkey model is drilled and tapped for a scope base.

CLEANING AND MAINTENANCE SUGGESTIONS

PLEASE TAKE NOTE OF THE FOLLOWING INFORMATION BEFORE CLEANING

YOUR SHOTGUN.

CLEANING PARTS WITH SPECIAL FINISHES

Be especially careful when cleaning guns with camouflage,

Dura-Touch® Armor Coating and other special finishes. Always

prevent these surfaces from coming in contact with cleaning solvents,

barrel scrubbers and other strong chemicals. It is preferable to clean

these surfaces with a light gun oil containing no solvents or with a

damp cloth and mild dish soap (be sure to keep water out of the

action). When cleaning your firearm’s bore and action, protect the

external finishes from any contact with chemicals used. Also, avoid

any contact between external finishes and other strong chemicals like

those found in DEET-containing insect repellents, sunscreens, etc.

Damage to camouflage, Dura-Touch and other finishes caused by

chemicals is irreversible and unrepairable.

FIGURE 11

The precision rear sight is screw adjustable for

both horizontal and vertical correction.

Windage Adjustment

Vertical Adjustment

03-241-BFA-BPS OM w-Duratouch 5/11/05 4:21 PM Page 23