Owner's Manual

INVECTOR

™

TUBE SELECTION

To help you choose the correct choke tube for each hunting and

shooting situation, all Browning choke tubes are inscribed on the side

with the patterns they produce with both lead and steel shot. Each

choke tube also has notches in the top rim of the tube. These notches

are a code to allow you to determine the choke designation while the

tube is installed. Rim notches refer specifically to lead shot. You will

need to use the chart below to cross-reference from lead to steel and

determine the appropriate tubes for your ammunition and

hunting/shooting situation.

Several tubes are supplied with your Browning shotgun. The tubes

listed are also available as accessories. Remember, Invector-Plus

™

and

Standard Invector

™

tubes are not interchangeable. Invector-Plus tubes

are for Browning guns with back-bored barrels and are not for use on

older BPS shotguns. Before removing/installing tubes, or reading the

rim notch code, make sure your shotgun is fully unloaded.

FIGURE 10A

Cylinder

Full

Imp. Modified

Modified

Imp. Cylinder

Skeet

FIGURE 10

A — Invector-Plus

™

choke tube

B — Standard Invector

™

choke tube

03-241-BFA-BPS OM w-Duratouch 5/11/05 4:21 PM Page 20