Owner's Manual

20
4 Cartridges in the magazine may be removed by sliding them
forward and out of the magazine with the thumb.
TRIGGER
The trigger mechanism has been adjusted at the factory to provide a
short, crisp pull. It is recommended that no attempt be made to change
these adjustments by anyone other than a qualified gunsmith at a local
Browning Recommended Firearms Service Center or by our Service
Facility in Arnold, Missouri.
SIGHT ADJUSTMENT
BEFORE PERFORMING SIGHT ADJUSTMENT PROCEDURES, MAKE SURE
YOUR RIFLE IS COMPLETELY UNLOADED. REMOVE THE MAGAZINE, CHECK
THE ACTION AND CHAMBER FOR CARTRIDGES. KEEP THE MUZZLE POINTED
IN A SAFE DIRECTION. FAILURE TO FOLLOW THESE WARNINGS COULD
RESULT IN SERIOUS INJURY OR DEATH.
WINDAGE: To move the point of impact to the right, use a coin or
screwdriver to loosen the screw located on the right side of the rear sight
by turning it in a counterclockwise direction. Tighten the screw on the left
side by turning it in a clockwise direction (Figure 9). This causes
the rear sight to move to the right. To move the point of impact to the
left loosen the screw located on the
left side of the sight by turning in a
counterclockwise direction. Tighten
the screw on the right side by
turning in a clockwise direction.
ELEVATION: Elevation
adjustment of the rear sight is
controlled by the screw located on
top and to the rear of the sight. To
raise the point of impact, turn the
screw in a clockwise direction
FIGURE 9
Rear sight horizontal adjustment.