Manual

6 With the bolt

locked in the open

position, slide the

forearm all the way

down until it fits

onto the receiver.

When fitting the

forearm onto the

receiver, grasp the

forward end of the

forearm and pull it

away from the bar-

rel. (See Figure 20.)

Be very careful in

reassembly of the

forearm, since it

can be broken if

forced into posi-

tion incorrectly.

ADJUSTING

THE SIGHT

The BAR is available with or without open sights. Always unload your

rifle before making any alignment to the sights. Remember, always move

your rear sight in the same direction you want the point of the bullet

impact to move. If you want the point of bullet impact to move to the

left, move the rear sight setting to the left. If you want to raise the point

of impact, raise your rear sight setting.

1 If horizontal or windage correction is desired, loosen or tighten the

screw on the side of the rear sight notch to the desired setting.

(See Figure 21.) Each calibration mark represents

approximately 1/4

inch movement of the point of impact at 100 yards.

2 If vertical correction is desired, loosen or tighten the vertical adjust-

ment screw located in front of the rear sight notch. Again, calibration

marks on the sight represent approximately 1/4 inch at 100 yards.

Fit forearm over gas piston

and onto receiver.

FIGURE 20

FIGURE 21

98355/BAR OM 8/7/03 10:49 AM Page 22