Manual

5 Perform any clean-

ing of the parts

and receiver cavity

as necessary.

DO NOT DISASSEMBLE

THE TRIGGER GROUP

BEYOND THIS POINT.

TRIGGER

GROUP

REASSEMBLY

1 Before reinstalling

the trigger group,

make sure that the

breech bolt is fully

forward and en-

gaged in the locked

position.

2. Visually check the

safety on the trigger

guard to make cer-

tain it is still in the

ON SAFE position.

3 Insert the trigger

group back into

the receiver, lining

up the holes in the

trigger assembly

with the holes on

each side of the

receiver.

4 Re-insert the trigger guard pins from either side of the receiver and

gently tap them into place again using caution not to scratch the

receiver. (See Figure 8.)

FIGURE 7

Remove trigger assembly.

FIGURE 8

Re-insert trigger guard pins.

FIGURE 6

Push trigger guard pins

entirely through receiver.

98355/BAR OM 8/7/03 10:49 AM Page 14