Manual

To unload the magazine merely push forward on the base of each
round until it clears the retaining lips. The last step is to close the
floorplate either without the magazine or with an empty magazine in
place.
TRIGGER
The trigger mechanism has been adjusted at the factory to provide a
short crisp pull, yet one consistent with safety. The trigger is a single
stage design with the weight of pull holding closely to 4 pounds. It is
recommended that no attempt be made to change the weight of pull
of the trigger.
REMOVING THE TRIGGER GROUP
This procedure should rarely, if ever, need to be performed. However,
if the receiver area of your BAR should become excessively dirty it
may be helpful to remove the trigger group and expose the inner
cavity of the receiver for cleaning.
DO NOT ALTER OR ATTEMPT TO DISASSEMBLE ANY PART OF THE TRIGGER
GROUP OR REMOVE OR DISASSEMBLE THE BREECH BOLT MECHANISM.
If any service of the trigger group becomes necessary, take your BAR
Mark II to a recommended Browning Service Center or send it to our
service center in Arnold, Missouri.
DISASSEMBLY
1 First, make certain the gun is totally unloaded and the safety is ON
SAFE.
2 Release the breechblock to its forward position by depressing the bolt
release lever. Swing open the magazine.
3 Push in the two trigger guard pins from either the right or left side of
the receiver. Use a drive punch or similar object, using caution not to
scratch the gun’s receiver. (See Figure 6.) Push the trigger guard pins
clear through the receiver.
4 Grasp the trigger guard and pull the trigger assembly out of the
receiver. (See Figure 7.)
13
98355/BAR OM 8/7/03 10:49 AM Page 13