Owner's Manual

31
TRIGGER GROUP INSTALLATION
1 Before reinstalling the trigger group, make sure that the bolt is fully
forward and engaged in the locked position.
2 Visually check the “safety” on the trigger guard to make certain it is
still in the on safe position.
3 Insert the trigger group back into the receiver, lining up the holes
in the trigger group with the holes on each side of the receiver.
4 Insert the trigger group pins from either side of the receiver and
gently tap them into place using care not to scratch the receiver.
Your firearm is now fully assembled. Immediately confirm that the
“safety” is in the on safe position. Take time to wipe down and clean
all external surfaces as explained under “Cleaning and Maintenance
Suggestions” on pages 26-29.
CLEANING THE MAGAZINE
WEAR EYE PROTECTION WHEN DISASSEMBLING AND CLEANING THE
MAGAZINE TO PREVENT SPRINGS, SPRING LOADED PARTS, SOLVENTS OR
OTHER AGENTS FROM CONTACTING YOUR EYES, RESULTING IN INJURY.
Frequently inspect magazines to determine the need for cleaning as
lubricant and dirt will gradually collect in the mechanism. Normally,
the magazine should be cleaned after firing 500 to 1000 cartridges.
1 Remove the magazine from the rifle as explained previously.
2 Clean the magazine by spraying it both inside and out with an
aerosol solvent that will not adversely affect the polymer magazine
follower or corrode the metal components.
3 Shake all excess solvent from the magazine and dry with a cloth or
blow dry with compressed air, if available.
4 Wipe off any dirt or residue, then apply a very thin coat of oil and
wipe clean again.