Owner's Manual

If any service of the trigger group or bolt becomes necessary, contact

our Service Facility in Arnold, Missouri, or a qualified gunsmith.

TRIGGER GROUP REMOVAL

1 Be certain the rifle is completely unloaded and the “safety” is in

the on safe position.

2 Release the bolt to its forward position by pressing down on the

bolt lock as detailed previously.

3 Push in the two trigger group pins from either the right or left side

of the receiver. Use a drive punch or similar object, using care not

to scratch the firearm’s receiver (Figure 16). Push the trigger group

pins clear through the receiver and remove them.

4 Grasp the trigger guard and pull the trigger assembly out of the

receiver (Figure 17).

5 Perform any cleaning of the parts and receiver cavity as necessary

using a quality aerosol gun solvent. Allow it to dry completely,

then very lightly oil the moving parts.

NOTICE! DO NOT DISASSEMBLE THE TRIGGER GROUP BEYOND THIS

POINT. THIS IS A SPECIALIZED, FINELY FITTED MECHANISM; ANY

ATTEMPT TO DISASSEMBLE THE TRIGGER GROUP MAY DAMAGE IT

BEYOND REPAIR.

FIGURE 17

Lift the trigger group from the receiver.

FIGURE 16

Tap the trigger group pins through the receiver.