Owner's Manual

26
Make certain you have the proper shim installed and in position
before reattaching the buttstock and recoil pad (Figure 15).
NOTICE! DO NOT USE MORE THAN ONE SHIM ON THE BUTTSTOCK .
5 When you are satisfied with the fit, reattach the buttstock to the
receiver with the washer and the screw.
6 Snug the stock screw with a screwdriver, do not overtighten.
7 Attach the recoil pad with care, so as not to scratch or mar
the finish of the stock. Wipe any excess petroleum jelly off the
recoil pad.
CLEANING AND MAINTENANCE SUGGESTIONS
NOTICE! PLEASE TAKE NOTE OF THE FOLLOWING INFORMATION BEFORE
CLEANING YOUR FIREARM.
CLEANING PARTS WITH SPECIAL FINISHES
Be especially careful when cleaning guns with camouflage, Dura-Touch
®
Armor Coating and other special finishes. Always prevent these
surfaces from coming in contact with cleaning solvents, barrel
scrubbers and other strong chemicals. It is preferable to clean these
surfaces with a light gun oil containing no solvents, or with a damp
FIGURE 15
The six stock shims move the stock as shown above