Owner's Manual

22
Many gunsmiths find it helpful to use a drop of serviceable thread
locking compound to assure the screws stay tight. Make sure the
thread locking compound does not get into the action.
Be careful to insure that the threads of each screw engage properly
in the receiver to prevent stripping the threads in the receiver.
7 Tighten the screws snugly, but do not overtighten.
8 Mount your scope rings and scope as outlined in the instructions
supplied with your scope rings and/or scope. Always make sure
you have the proper eye relief.
STOCK ADJUSTMENT
BEFORE PERFORMING STOCK ADJUSTMENT PROCEDURES, PLACE THE
“SAFETY” IN THE ON SAFE POSITION. REMOVE THE MAGAZINE, OPEN
THE ACTION AND MAKE CERTAIN YOUR RIFLE IS COMPLETELY UNLOADED.
KEEP THE MUZZLE POINTED IN A SAFE DIRECTION. FAILURE TO FOLLOW
THESE WARNINGS COULD RESULT IN SERIOUS INJURY OR DEATH.
Three recoil pads of different lengths are available to allow you to
change the length of pull of the BAR ST/LT. Also, six shims are
included with your rifle to fine-tune cast and drop (shim 2 is installed
on the rifle from the factory). These accessories allow the stock to be
adjusted to adapt the fit of the rifle
to your body.
ADJUSTING LENGTH OF PULL
Three recoil pads are available to
allow precise length of pull
adjustments (Figure 10). The short
recoil pad is ½" thick, the medium
recoil pad is ¾" thick and the
long recoil pad is 1" thick. The
medium recoil pad is installed
on the rifle from the factory. To
FIGURE 10
Three recoil pads are available to customize fit.