Owner's Manual

is a recess or index mark

that the set screw must

tighten against. When

sliding the action spring

guide into the piston

make sure to align the

index mark on the

action spring guide with

the the set screw hole on

the receiver (Figure 19).

It may be helpful to

access the action spring

guide through the

magazine well to help

align the index mark

with the set screw hole.

CAUTION: FAILURE TO

TIGHTEN THE SET SCREW

AGAINST THE INDEX MARK IN THE ACTION SPRING GUIDE COULD

CAUSE THE FIREARM TO MALFUNCTION AND CAUSE SERIOUS

INJURY TO YOURSELF AND OTHERS.

3 Push the cross pin back in place and replace the set screw, making

sure the index mark in the action spring guide is aligned with the

set screw hole and the set screw tightens firmly against the index

mark on the action spring guide.

4 To replace the action bars, first place the bolt in its most forward

position. It is helpful to leave the magazine floorplate in the open

position so you can check alignment of the action bars on the bolt.

Place the projecting section of each action bar carefully in its

corresponding slot in the slide before the action bar is fit onto the

inertia piece (Figures 20A and 20B). The action bars are

interchangeable. It may be necessary to pull the inertia piece slightly

rearward to engage the action bars.

FIGURE 20B

Inserted action bar.

FIGURE 20A

Insert action bar into

corresponding slot.

03-052-BFA_BAR Shrt-LTrac_4 6/18/04 11:55 AM Page 22