Owner's Manual

and pull the action bar
out of the receiver.
4 Loosen and remove the
set screw that holds the
action spring guide in
place using a 3mm Allen
wrench (Figure 15).
5 Push the cross pin,
located directly behind
the set screw (Figure 15),
out using a small
instrument like a punch.
6 Pull the inertia piece
rearward against the action
spring until the action
spring guide is exposed
(Figure 16). NOTE: The
inertia piece is under heavy
spring tension and care
should be used to avoid
injury and lost mechanical
parts. Slide the action
spring guide rearward, out
of the piston, until the
inertia piece and action
spring can be removed
from the action spring
guide (Figure 17). NOTE:
Once you begin to slide the action spring guide rearward it may be
useful to reach inside the magazine well and pull the action spring
guide from the rear.
7 The inertia piece can then be disassembled for cleaning by
pulling back against the two plunger springs and lift up and
outward (Figure 18). NOTE: The inertia piece is under rigid
20
FIGURE 17
Slide the action
spring guide
rearward.
FIGURE 16
FIGURE 15
Remove the
set screw.
Pull the inertia piece rearward.
Cross pin.
Set screw.
03-052-BFA_BAR Shrt-LTrac_4 6/18/04 11:55 AM Page 20