Owner's Manual

present. Once this is determined the bolt may be allowed to close by
depressing the bolt release lever.
To unload the magazine merely push forward on the base of each
round until it clears the retaining lips. The last step is to close the
floorplate either without the magazine or with an empty magazine
in place.
TRIGGER
The trigger mechanism has been adjusted at the factory to provide a
short, crisp pull consistent with safety. The trigger is a single stage
design with the weight of pull holding closely to 4 pounds. It is
recommended that no attempt be made to change the weight of pull
of the trigger.
REMOVING THE TRIGGER GROUP
If the receiver area of your BAR should become excessively
dirty it may be helpful to
periodically remove the
trigger group and expose the
inner cavity of the receiver
for cleaning.
DO NOT ALTER OR ATTEMPT TO
DISASSEMBLE ANY PART OF
THE TRIGGER GROUP OR
REMOVE OR DISASSEMBLE THE
BREECH BOLT MECHANISM.
If any service of the trigger
group becomes necessary,
take your BAR to a
recommended Browning
Service Center or send it
to our Service Center in
Arnold, Missouri.
14
FIGURE 8
Remove trigger assembly.
FIGURE 7
Push trigger guard
pins entirely
through receiver.
03-052-BFA_BAR Shrt-LTrac_4 6/18/04 11:55 AM Page 14