User Guide

into the hole in the
gas piston. To be
sure that the gas
piston is properly
aligned in the gas
cylinder, the gas pis-
ton should be able
to be pushed par-
tially out of the rear
end of the gas cylin-
der when the iner-
tia block is pulled
away from the gas
cylinder.
3 Screw on and
tighten the gas
cylinder screw cap
on the front of the
gas cylinder.
4 Replace the action
bars: Place the bolt
in its forward position. It is helpful to release the magazine floorplate
to the open position so you can check alignment of the action bars
on the bolt. Place the projecting section of each action bar carefully in
its corresponding slot in the bolt before the action bar is fit onto the
inertia piece. (See Figure 18.) The action bars are interchangeable. It
may be necessary to pull the inertia piece slightly rearward to engage
the action bars.
5 Replace the bolt release spring and bolt release lever and pin: Close
the magazine floorplate and keep the bolt in its forward position. Re-
place the bolt release spring. (See Figure 19.) Replace the bolt release
lever. Line the hole in the bolt release lever with the hole in the receiv-
er and insert the bolt release pin. Lock the bolt release spring onto the
bolt release lever.
21
FIGURE 19
FIGURE 18
Replace bolt release spring.
Replace action bars.
98355/BAR OM 8/7/03 10:49 AM Page 21