User Guide

action bar by first

releasing the bolt

release lever spring

from the bolt release

lever and removing

the spring from the

receiver. (See Figure

10.) Remove the bolt

release lever pin and

pull the bolt release

lever forward and

out of the receiver.

(See Figure 11.) You

can then pull the

forward end of the

action bar away

from the inertia

piece and lower and

pull the action bar

out of the receiver.

4 Remove gas cylinder

screw cap from the

forward end of the

gas cylinder: Turn

in a counter-clock-

wise direction. (See

Figure 12.) Use an

11/16" wrench for

this step.

5 Remove the gas pis-

ton: The inertia

block should be

pulled back toward the receiver until rear face of the gas piston can be

pushed forward out of the gas cylinder with a small soft drive punch.

(See Figure 13.)

FIGURE 13

Remove gas piston.

FIGURE 12

Remove gas cylinder screw cap.

FIGURE 11

Remove bolt release

lever pin.

98355/BAR OM 8/7/03 10:49 AM Page 18