User Manual

gas cylinder and pushed rearward over the end
of the action spring guide. Care must be taken to
insure that the small guide pin at the rear of the
gas cylinder is engaged in the lengthwise groove
on the rear portion of the gas piston. To be sure
that the gas piston is properly aligned in the gas
cylinder, the gas piston should be able to be
pushed partially out of the rear end of the gas
cylinder when the inertia block is pulled away
from the gas cylinder.
The gas regulator is now assembled into the
front of the gas cylinder. The gas regulator must
be very securely tightened using the slot wrench
provided.
The action bars and support rails are next
replaced. The projecting section of each action
bar is carefully placed in its corresponding slot in
the bolt before the hole in its forward end is
placed over the stud on the inertia piece. It may
be necessary to pull the inertia piece slightly
rearward to engage the action bars. The support
rails are next installed.
The bolt is locked into its open position and the
reassembly of the forearm is just the reverse of
steps “1” through “2” above. Be very careful in
reassembly of the forearm, since it can be
broken if forced into position incorrectly.
The wood surfaces can be wiped with Browning
Gun Oil or polished with any quality furniture
wax.
40