User Manual

The bolt and interior of the receiver
should be wiped off with a clean rag. This
is best done with the magazine floorplate
open and the bolt in its closed position;
and also with the magazine floorplate
open and the bolt held to the rear by hand.
Any dried oil in these areas and on the
magazine follower should be removed.
Follow this cleaning by applying a very
light film of oil on the affected parts. Do
not, however, pour large quantities of oil
into the action. An excess of oil will run
into the wood and cause it to soften or
warp.
Wipe all exposed metal surfaces with an
oiled cloth, making sure to wipe gun clean
of all finger marks where moisture will
accumulate. Ordinary good judgment will,
of course, indicate that the metal of the
gun should receive a light film of oil any
time the gun has been exposed to adverse
weather or handling.
CLEANING INSTRUCTIONS: To insure
proper functioning of your BAR it should
be periodically inspected and cleaned. Any
time when sluggish or incomplete
operation of the action is experienced
while using commercial ammunition, the
action should be cleaned. Generally, once
33