User Manual

If vertical correction is desired, loosen the
vertical adjustment screw and slide the rear
sight assembly along the inclined ramp of
the sight base. Again calibration marks on
the sight will reference movement, and simi
-
larly, each calibration mark represents
approximately 4 inches at 100 yards.
Just remember this simple rule in making
rear sight adjustments. Always move your
rear sight in the same direction you want
the point of bullet impact to move. If you
want the point of bullet impact to move to
the left, move the rear sight setting to the
left. If you want to raise the point of
impact, raise your rear sight setting.
To adjust a telescopic sight on your BAR
rifle, the same general procedure, outlined
above, may be followed to sight in the rifle,
except the adjustment of the telescopic
sight should be made according to the
instructions supplied by the maker of the
sighting instrument used.
To obtain the 200 yard zero preferred by
many experienced hunters on a 100
YARDS RANGE refer to the table in Figure
6. Merely adjust the sights in the manner
prescribed above so that at the 100 yards
range, the center of impact of your bullet
group is located at the distance ABOVE
30