User Manual

telescopic sights. To adjust the BAR’s open
rear sight proceed as follows: Always
unload your rifle before making any
alignment to the sights.
If horizontal or windage correction is
desired, slightly loosen the screw
immediately in front of the rear sight
notch. (This windage screw is set in a
bright metal collar; the screw next to it is
the vertical adjustment screw. Refer to
Figure 7.) Slide the rear sight blade in the
direction you wish the bullet impact to
move. The base containing the rear sight
blade is precisely calibrated for referencing.
Each calibration mark represents
approximately 4 inches of movement of
the point of impact at 100 yards.
29