Manual

found on the bottom side of the breechblock
(See Figure 12). The breechblock lever serves
to retain the breechblock in the receiver.
(SPECIAL NOTE: It is possible to remove
the breechblock first before removing the
trigger group. You will need simultaneously
push rearward 1/4" on the breechblock
and “reach” in through the opening at the
front of the carrier to depress the
breechblock lever, using the eraser end of
a pencil, a small wood dowel, a
screwdriver, or other similar object.)
With the breechblock lever pressed, remove
the breechblock forward, out of the front
of the receiver. The action springs will stay
attached to the breechblock, projecting
from the rear The breechblock is now fully
removed DO NOT DISASSEMBLE THE
BREECH BLOCK BEYOND THIS POINT.
Reassembly: Trigger Group and
Breechblock
REINSTALLING THE BREECHBLOCK
ASSEMBLY -
1
Insert the breechblock into the receiver
opening, action springs first. The guides on
39