User Guide

Line up the hole in the trigger guard with
the holes on each side of the receiver.
Insert the trigger guard retaining nut
completely through the receiver. Start the
retaining screw with your fingers and tighten
using two screwdrivers, one for each
slotted head on each side of the receiver.
Three-Shot Magazine Adapter
The following instructions are for disassembly of
the magazine, and the removal or installation of
the three-shot magazine adapter. Steps 1-8 detail
magazine disassembly, and are the same for
both removal and installation of the three-shot
adapter. Steps 9-A and 9-B explain reassembly of
the magazine with or without the three shot adapter.
The A-500 shotgun is delivered with the three-
shot magazine adapter installed in the magazine,
limiting magazine capacity to two shells —
allowing three shots total in compliance with
federal migratory bird regulations. If you do not
wish to be limited to three shots — when it is
not required by law — you can remove or
reinstall the three-shot adapter (plug) as follows:
ALWAYS WEAR PROTECTIVE SAFETY
GLASSES DURING THIS OPERATION.
42