User Guide

performed by a competent gunsmith. ALWAYS
WEAR EYE PROTECTlON WHEN PERFORMING
ANY MAINTENANCE OR DlSASSEMBLY.
REMOVING THE TRIGGER GROUP — You will
need two medium blade screwdrivers to remove
the trigger guard retaining screws (the trigger
guard retaining nut and the trigger guard
retaining screw). Make sure the screwdrivers are
of appropriate size to prevent damage to the
slotted heads. No other tools are necessary.
Remove the barrel as explained under
“Disassembly. . . ” on page 21. Set the
forearm, as well as the forearm buffer and
spring, aside.
Release the breechblock to its forward position
as follows: While holding the operating
handle back (by applying rearward pressure)
depress the breechblock release button.
Allow the breechblock to travel slowly
forward, controlling and slowing its
forward travel until it is fully forward. The
head of the rotary bolt should project
about 1/2” from the front of the receiver.
Insert a screwdriver into the retaining nut
slot and the other screwdriver into the
retaining screw slot. Hold one side from
35