User Guide

hand and unscrew and remove the
magazine cap. Remove the forearm from
the magazine tube by sliding it forward off
the magazine tube.
Position the recoil spring and the forearm
buffer on the magazine tube. (The forearm
buffer goes on first, followed by the recoil
spring.) Position them forward with the
leading edge of the spring at the front
edge of the magazine tube.
Hold the receiver and the magazine tube
level, and at the same time position the
barrel with the guide ring over the
magazine tube, and the barrel extension at
the receiver opening. The lower edge of
the barrel extension guide must be behind
the forearm buffer (See Figure 5).
Slide the barrel rearward seating the barrel
extension rails in the receiver tracks. The
barrel extension may hang up slightly
where the extension contacts the
breechblock. If it does, position the gun
vertically (barrel up) and pull rearward on
the operating handle, until the extension
slips into position.
Slide the forearm onto the magazine tube
(over the recoil spring and forearm buffer)
20