User Guide

are it removing the three-shot adapter
OR insert four 2 3/4" shells (or three 3-
inch magnums) if the three-shot adapter
was removed previously and you are it
reinstalling it. Position an additional
shells as if you were going to insert it
into the magazine (it will stop only par-
tially inserted because of the full maga-
zine).
5. Apply steady, hard pressure on the shell,
pushing all the shells forward in the
magazine until the magazine spring re-
tainer is dislodged from its compressed
fitting at the end of the magazine (See
Figure 16). You will feel forward move-
ment of the shells in the magazine when
it is dislodged.
IF IT WILL NOT DISLODGE WITH
STEADY PRESSURE you may have to
work the last shell in and out to increase
FIGURE 16
force on the shells in the magazine. If
this also fails to dislodge the magazine
spring retainer, place another shell be-
hind the one partially inserted and apply
increased pressure with the palm of
your hand, or strike the back of the last
shell with the palm of your hand until
35