User Guide

on the breechblock must fit in the re-
ceiver tracks. Make sure the front action
springs fit over the ends of the action
spring guides (See Figure 14). Push the
breechblock in far enough so that the
breechblock lever engages, holding the
breechblock in the receiver. Simultane-
ously push back on the breechblock
while depressing the breechblock re-
lease button until the notch in the ejec-
tion port lines up with the operating
handle recess on the breechblock. Make
sure that the action springs are com-
pressed inside the recesses in the
breechblock, and that the ends of the ac-
tion spring guides start into the recesses
in the breechblock without kinking the
front action springs.
2. Insert the operating handle into the re-
cess (Refer to Figure 12-B). The breech-
block is now installed.
REINSTALLING THE TRIGGER GROUP —
1. Reinsert the trigger group into the bot-
tom of the receiver, moving it rearward
to assure correct location of the rear pins
into the holes in the receiver. Then start
at the back and hinge the trigger guard
forward (See Figure 15).
with the holes on each side of the re-
ceiver. Insert the trigger guard retaining
nut completely through the receiver.
Start the retaining screw with your fin-
gers and tighten using two screwdrivers,
one for each slotted head on each side
of the receiver.
2. Line up the hole in the trigger guard
33