User Guide

FIGURE 13
With your left hand, push on the bolt
head moving the breechblock about 1/2"
back into the receiver, lining up the op-
erating handle with the notch at the bot-
tom front of the ejection port (See Figure
12-A). With your right hand grasp the
operating handle and pull it outward,
removing it from the breechblock (See
Figure 12-B).
2. The breechblock will now be able to
move forward about another 1/2”. Again,
push rearward on the bolt head, depress-
ing the breechblock back into the re-
ceiver about 1/4". With your right hand,
reach in with a finger and push on the
breechblock lever found on the bottom
side of the breech block (See Figure 13).
The breechblock lever serves to retain
the breechblock in the receiver.
SPEClAL NOTE: It is possible to remove
the breechblock first before removing
the trigger group. You will need to
simultaneously push rearward 1/4" on
the breechblock and "reach" in through
the opening at the front of the carrier to
depress the breechblock lever, using the
eraser end of a pencil, a small wood
dowel, a screwdriver, or other similar
object.)
31