User Guide

REMOVING THE TRIGGER GROUP —
You will need two medium blade screw-
drivers to remove the trigger guard retaining
screws (the trigger guard retaining nut and
the trigger guard retaining screw). Make
sure the screwdrivers are of appropriate size
to prevent damage to the slotted heads. No
other tools are necessary.
1. Remove the barrel as explained under
“Disassembly’ on page 18. Set the fore-
arm, as well as the forearm buffer and
spring, aside.
position as follows: While holding the
operating handle back (by applying rear-
ward pressure) depress the breechblock
release button. Allow the breechblock to
travel slowly forward, controlling and
slowing its forward travel until it is fully
forward. The head of the rotary bolt
2. Release the breechblock to its forward
FIGURE 10
should project about 1/2” from the front
of the receiver.
3. Insert a screwdriver into the retaining nut
slot and the other screwdriver into the
retaining screw slot. Hold one side from
turning while unscrewing the opposite
side (See Figure 10).
29