Manual

Browning 92
SERIAL NUMBER
The serial number of your rifle can be found on the
right side of the receiver.
1
CLEAN THE ANTI-RUST COMPOUND from
the barrel and the inside of the receiver with
a clean rag and light gun oil such as Brown-
ing Gun Oil or Browning Liquid Gunsmith.
THROUGHOUT THE LOADING PROCESS
2*
MAKE CERTAIN THE RIFLE IS POINTED
IN A SAFE DIRECTION.
For maximum
safety, you should never chamber a cartridge
until a shot
is imminent.
3.
LOADING IS ACCOMPLISHED BY INSERT-
ING THE CARTRIDGES NOSE FIRST
THROUGH THE LOADING PORT
on the
right side of the receiver (see
fig. 2). The ca-
pacity of the magazine
is 11 rounds. Another
cartridge may be placed in the chamber to
provide a total capacity of 12 rounds.
In the event you wish to carry all 12 rounds,
you must first insert 11 rounds into the mag-
azine tube and then cycle the action to cham-
ber a round. Immediately place the hammer
in the half cock position as described in the
"safety" section of this manual. The twelfth
round can now be inserted into the magazine
tube as before.
4.
WITH A ROUND IN THE CHAMBER, YOU
NEED ONLY THUMB THE HAMMER BACK
TO ITS FULL COCK POSITION TO READY
THE RIFLE FOR FIRING.
Otherwise, cycling
the lever to place
a round in the chamber will
leave the hammer in the full cock position.
Browning 92
Schematic is provided for parts identification only
and should not be used as a guide to assemble guns.