Manual

You can now easily clean all of these com-
ponents as well as the inside of the receiver.
(See Figure 23.) Again a good solvent is
ACTION SPRING
BOLT SLIDE
CARTRIDGE STOP
recommended. Further disassembly of the
trigger group is not recommended.
NOTE: Do not apply large quantities
of oil to the trigger group or other areas of
the action. Excessive oil is not necessary and
serves to collect dust and minute particles of
dirt. Excessive oil could also soak into the
stock; softening the walnut and loosening the
stock. Only a very, very light film of fine
quality gun oil is needed to protect these
working parts.
REASSEMBLY OF THE ACTION
Follow the steps below:
1. Slide the action spring onto the maga-
zine tube, compress the action spring
and start the action bar assembly onto
the magazine tube. Grasp the action
bar assembly keeping the spring
slightly compressed.
2. Assemble the bolt and bolt slide and
align the action bars in their respective
27