Manual

SHOCK ABSORBER GROUP
(Stripping ofthis group is rarely needed except in case ofrepair)
(1) Unscrew adjusting screw.
(2) Remove adjusting screw plunger and the adjusting screw
plunger spring.
(3) Remove buffer discs (there are 16 of these), buffer plug,
buffer ring and buffer plate.
BOLT
(1) Remove extractor.
(2) With cocking lever in rearmost position insert point of
bullet into trigger notch of sear. Press sear downwards, releasing
striker.
(3) Push out cocking lever pin.
(4) Remove cocking lever.
(5) With point of bullet push scar spring to left side of bolt.
(6) Remove scar downwards. Replace sear spring in original
position, sear spring and scar spring pin can now be removed
upwards.
(7) Tilt bolt upwards and striker and spring assembly will
fall out.
(8) To remove striker spring, push out striker spring retaining
pin, taking care not to allow spring to fly out.
(9) Remove driving rod and driving spring by tUrning driving
rod notch to horizontal position and withdrawing spring and
rod under control. (The driving spring is long, and care should
be taken not to kink it. A quick withdrawal of driving rod will
prevent this.)
II