Installation & Assembly

brownjordanres.com
© 2016 v280616
Installation
FLO, ARROYO
Equipment required: Chosen decorative media such as lava rocks or
re/heat suitable pebbles or glass. Conrm quality and suitability of re
accessories to ensure the accessories will not explode, emit carbon
monoxide or fumes when exposed to extreme temperature variations.
1. Insert the Adapter Plate into the base (COLLAR FACING UPWARDS).
2. Add the majority of the chosen decorative media around the unit
platform. Do this before inserting the burner to avoid scratching the
surface of the burner.
3. Insert Burner on top of Adapter Plate then carefully adjust or add
more of the decorative media around the burner - be careful not to
scratch the burner surface.
Do not place decorative media on top of the burner or where they can
interfere with the operation of the burner or the ame.
4. Insert two clips into the top and bottom of the cosmetic cap. (Four
clips are supplied but only one or two will be needed in most cases).
5. Insert the cosmetic cap into position. The remaining part (similar
to the cosmetic plate) packed with your unit is not required for
bioethanol fuelled installations.
6. If you nd it too loose - add an additional clip to the side/s to tighten
up the t, if it’s too tight - remove one of the clips until the best t is
achieved. The remaining part (similar to the cosmetic plate) packed
with your unit is not required for bioethanol fuelled installations.
OPERATE ACCORDING TO THE BURNER OPERATIONS MANUAL
INCLUDED WITH THE BURNER.
LUMEN
Equipment required: Timber/Wood: Pencil, short philips head screw
driver, drill and pilot drill bit. Concrete/Stone: Pencil, short Philips head
screw driver, hammer, masonry drill and masonry bit.
1. Check rubber feet are in place;
2. Insert the burner into the base.
To x into a permanent position:
Note: Rubber feet must remain attached even if xing in a permanent position.
a. Conrm you have received all necessary parts as illustrated. For
installing against a timber/wood surface you will need part A. For
installations against a concrete/stone surface you will need part B;
b. Use the central hole as a template for drill hole centre;
c. Move replace and drill a hole according to the screw / material
outlined in point ‘a’ above;
d. Re-position replace & x screw through hole in base plate to oor;
e. Insert the burner into the base as seen in image 2.
OPERATE ACCORDING TO THE BURNER OPERATIONS MANUAL
INCLUDED WITH THE BURNER.
1. 1.
3. a.
5. c.
2. 2.
4. b.
6. d.
A x 1 B x 1