Installation & Assembly
When using Bioethanol as a fuel source this model is suitable for indoor
and outdoor use.
Before installation ensure that the model is positioned in accordance
with the compulsory minimum clearances outlined below.
WARNING: Ensure that your re is positioned away from
ammable materials and other sources of ignition at all times.
Pay very close attention to positioning the re away from items
that may move as a result of wind and drafts. For example trees/
branches/paper and the like.
The base of the burner within the model must never come into direct
contact with ammable materials.
Side clearances to xed and stable furniture items that are not
susceptible to movement such as lounges or patio furniture must remain
a minumum of 600mm [23.6in] away from the ame at all times.
Overhead clearances to items that are susceptible to movement
(e.g. Trees) must remain a minimum of 2000mm [78.7in] away from
the ame at all times.
Note: Stainless steel will rust or corrode over time if contamination
or debris is not cleaned or removed immediately. When not in use, it
is recommended that you protect your replace from water damage
or corrosion with a protective cover and always use the Burner Lid
included with your model to safeguard the burner.
These products feature 360º height-adjustable articulating feet. Adjust
the feet by turning them in either direction until you achieve a perfectly
level and stable model before operating.
IMPORTANT
1. Concrete is a porous material. It is important to avoid dripping
liquid (such as bioethanol or alcohol) onto the concrete
surfaces as it may break down the sealer and stain the surface
permanently.
2. Do not put HOT burner lids down on the concrete surfaces. It
could damage the model.
Please refer to the Care & Maintenance document included with
your model (and available online).
Clearances Installation
EQUINOX, RISE, URTH, STRATA, QUAD,
LOOP TABLE, SOLSTICE, KOVE
Equipment required: Chosen decorative media such as lava rocks or
re/heat suitable pebbles or glass. Conrm quality and suitability of re
accessories to ensure the accessories will not explode, emit carbon
monoxide or fumes when exposed to extreme temperature variations.
1. Add the majority of the chosen decorative media around the unit
platform. Do this before inserting the burner to avoid scratching the
surface of the burner.
2. Insert Burner into base then carefully adjust or add more of the
decorative media around the burner - be careful not to scratch the
burner surface.
3. Do not place decorative media on top of the burner or where they
can interfere with the operation of the burner or the ame.
4. Insert two clips into the top and bottom of the cosmetic cap. (Four
clips are supplied but only one or two will be needed in most cases).
5. Insert the cosmetic cap into position.
6. If you nd it too loose - add an additional clip to the side/s to tighten
up the t, if it’s too tight - remove one of the clips until the best t is
achieved. The remaining part (similar to the cosmetic plate) packed
with your unit is not required for bioethanol fuelled installations.
OPERATE ACCORDING TO THE BURNER OPERATIONS MANUAL
INCLUDED WITH THE BURNER.
1.
3.
5.
2.
4.
6.
Outdoor Clearances