Owner's Manual

Chaprter 3 Programming with Command Function
Programmer
97
4. The needle point moves to 1'.
5
Saving
1. Specify the program number on the operation
panel, then press
switch for writing into the
floppy disk.
Refer to "Using the operation panel of the main body"(page 131)
for detailed operation.
6
Ending program
1. Press
P
.
Adding sewing point before the first stitch
A point is added before the current sewing point to
change the sewing start position.
The example in the left is used for explanation of
changing the sewing start position from 1 to 1'.
1
Calling data
1. Specify the program number on the operation
panel, then press
switch to read the data.
Refer to "Using the operation panel of the main body"(page 128)
for detailed operation.
2
Moving to position 1
1. Press
1
, then press .
The needle moves to the sewing start position.