Owner's Manual

153
Chapter 5 Practical programming examples
Programmer
23. Repeat step 22 and create the program to point
S.
24. Move the needle with . Press
L
7
8 9
when the needle point is at point T
of the pattern.
Point N is programmed tos be a corner.
25. Press
M
.
26. Repeat step 22 and create the program to point
Y.
27. Press
LILI
.
28. Move the needle with . Press
L
when
the needle point is at point Z of the pattern.
29. Press
9
, then press
LILI
.
9
is a command for needle tacking. Input the stitch length
in . 0.5 mm is input in the example.
30. Move the needle with . Press
L
when
the needle point is at point A of the pattern.
2
Input the end code
1. Press
E
1
1 1
.
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.