Owner's Manual

145
Chapter 5 Practical programming examples
Programmer
Operating procedure
1
Programming
1. Press
P
.
The work clamp comes down and the programmer screen is displayed.
2. Select with , then press .
3. Move the needle with . Press when
the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
4. Select with , then press .
5. Input the stitch length, then press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
6. Move the needle with . Press when
the needle point is at point B of the pattern.
7. When point B is programmed, press
ESCESC
twice.
8. Select with , then press .
9. Input the stitch length, then press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
10. Move the needle with . Press when
the needle point is at point C of the pattern.