Owner's Manual

140
Chapter 5 Practical programming examples
Programmer
21. Input the stitch length, then press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
22. Move the needle with . Press when
the needle point is at point G of the pattern.
23. Repeat step 22 and create the program to point
J.
24. When point J is programmed, press
ESCESC
twice.
25. Select with , then press .
26. Input the stitch length of needle tacking, then
press .
0.5 mm is input in the example.
Input 005 to make the stitch length to 0.5 mm.
27. Move the needle with . Press when
the needle point is at point A of the pattern.
28. Press
ESCESC
twice.
2
Input the end code
1. Select with , then press .
2. Press .
The needle goes back to the sewing start position and the retractable
clamp is positioned outside.