Owner's Manual

Programmer
13
Chapter 1 Initial Setup
Notes for programming
Pattern sheet
Use thin plotting paper or prepare copies of pattern sheet.
The pattern sheet is designed in the original scale.
Stitch length
Setting range between 0.3 and 6.0 mm is available.
As for the needle tacking data, values 0.1 to 1.0 mm are available.
Stitch count
Maximum available count is 1,000.
Selectable program numbers
Selectable program numbers vary depending on the clamps used when writing data.
When using a retractable clamp 00 ~ 31
When using other clamps 32 ~ 63
Attributes of data when reading the data of BAS760
Attributes of data are as follows when reading the data of BAS760.
Needle tacking Reflected
Two step tension Reflected
Two row switch Reflected(*)
Slow conversion Ignored
(*) Two step switch data is reflected in the normal position when reading the data complying with the
specifications for BAS760 retractable clamp.
As for other clamps, slow conversion instructions to 2500 rpm or 3000 rpm are reflected as the two
row switch data. Turn the setting of two row switch to off.
Available types of floppy disk
epytataDyromemroftnuochctitSnoituloserataDksiDtamroFdaeRetirW
ataD167SABnrettap/sehctits0001eslup/mm50.0DH2
V/SOD
BM44.1
elbaliavAelbaliavA
ataD067SABnrettap/sehctits0001eslup/mm1.0DD2
dettamroF
.yllacitamotua
elbaliavA
toN
elbaliava