Owner's Manual

138
Chapter 5 Practical programming examples
Programmer
Operating procedure
1
Programming
1. Press
P
.
The work clamp comes down and the programmer screen is displayed.
2. Select with , then press .
3. Move the needle with . Press when
the needle point is at point A of the pattern.
The first stitch (point A) is programmed.
4. Select with , then press .
5. Input the stitch length, then press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
6. Move the needle with . Press when
the needle point is at point B of the pattern.
7. Repeat step 6 and create the program to point
E.
8. When point E is programmed, press
ESCESC
twice.
9. Select icon with , then press .
10. Input the number of stitches to return the needle
to the position where two row switch is input,
then press .
5 is input in the example. The needle moves 5 stitches back.