Owner's Manual

Programmer
120
Chapter 3 Programming with Command Function
Moving in parallel
Command to be used
F
L
7
7 7
Moving data of the needle position after the current position in
parallel by feeding
LI
L
7
7 7
Moving data of the needle position after the current position in
parallel by stitching with the specified stitch length.
Specify the stitch length in 3 digits before pressing ?.
L
7
7 7
L
Moving data of the needle position after the current position in
parallel by stitching when the moving distance is 6.0 mm or less
and by feeding when it is more than 6.0 mm.
1. Move to the desired needle position.
Refer to page 112 on how to move the needle position.
When
F
L
7
7 7
2. Press
F
.
3. Determine the destination with
, then press
L
7
7 7
.
By feeding
By stitching with the
specified stitch length
All the stitches after A
are moved in parallel.
Displays the number of the command input.